1. Install “Base Cover” & “Post Cover” to protect Base & Posts when not using.

2.Remove “Base Cover” & “Post Cover” before install “Flood Barrier”, Clean & Check “Gasket” if broken or damage,. If yes, have to replace before install “Flood Barrier”.

3. Insert 1st barrier(which have handles under the barrier) into the base, push barrier down, Balance to lock tight left / right handles, Then lock tight the lower handles, finish handle, Same procedure as 3rd.4th.barriers.install 1st barrier.

4.If flood rise up, Install 2nd barrier, Just attach 2nd barrier above 1st barrier, Push down & balance to “Half Lock” Left / right, Then lock tight handle, Same procedure as 3rd.4th.barriers.

5.Install “Clip” in between 1st & 2nd barrier (About 50cm each), use tool lock tight. Same procedure as 3rd.4th…...barriers

6.After lock tight the clips, That’s the time to lock tight left / right handles, Same procedure as 3rd.4th…...barriers.

Introduction to single-person quick assembly (video)